What is the life expectancy of the M500A1 service shotgun?

What is the maximum effective range of the Mossberg 500A1 shotgun with a shot load? The M500A1 is typically used at ranges of up to 100 yards (91 m) with a shot load.

When reassembling the M500A1 service shotgun is?

When reassembling the M500A1 service shotgun, the fore-end is installed over this component. Which of the following actions represents Weapon Condition Code 4? Magazine tube empty, chamber empty, action closed, weapon on safe.

Which major component is the M500A1 service shotgun?

What are the four major component groups of the M500A1 service shotgun? -Stock group – is an extension of the receiver group and provides a support to shoulder-fire the shotgun. -Receiver group – houses the cartridge ejector and serves as support for all major groups and assemblies of the weapon.

Is any unintentional interruption in the cycle of operation?

A stoppage is an unintentional interruption in the cycle of operation. An example of a stoppage is the slide not going fully forward.

IT IS INTERESTING:  You asked: How much does a Remington sniper rifle cost?

What is the maximum effective range of the M500A1 service shotgun with a shot load?

What the maximum effective range of the M500A1 service shotgun with a shot load? 150 ft (46m) What is performed before staring a safety/function check? Clear the weapon. Which major component of the M500A1 service shotgun contains safety, ejection port, and fore-end?

What is the maximum effective range of the m500 shotgun?

Mossberg 500

Mossberg 590A1
Muzzle velocity 1,325 ft/s (404 m/s) for 12-gauge, 23⁄4″, 00 buckshot load 1,560 ft/s (480 m/s) for 12-gauge 437-grain rifled slug
Effective firing range 130 ft (40 m)
Maximum firing range 165 ft (50 m) for shot, 980 ft (300 m) for slugs
Feed system varies, 2+1 to 8+1 rounds; internal tube magazine

Which weapon handling command would take the weapon from Condition 1 to Condition 4?

7 Cards in this Set

Load Take the weapon from condition 4 to condition 3.
Load and Make Ready Take the weapon from condition 4 to condition 1.
Fire Engage the Target
Cease Fire Cease engagement of the target
Unload Take the weapon from Condition 1 or 3 to condition 4

What caliber is the M16A3 service rifle?

M16 rifle

Rifle, Caliber 5.56 mm, M16
Action Gas-operated, rotating bolt
Rate of fire 45–60 rounds/min semi-automatic 700–950 rounds/min cyclic sustained (M16A1) 700-900 rounds/min cyclic sustained (M16A2, M16A3) 800 rounds/min cyclic sustained (M16A4)
Muzzle velocity 3,150 ft/s (960 m/s) (M855A1 round)

What should you use for hard to clean areas on the M9 service pistol receiver area?

What should you use for hard to clean areas on the M9 service pistol receiver area? Use a soft brush for hard to clean areas.

IT IS INTERESTING:  Your question: What is the cost to Rebarrel a rifle?

What condition should the weapon be in when returned to the armory?

What condition should the weapon be in when returned to the armory? An operating or maintenance procedure, practice, condition, statement, etc., which if not strictly observed, WILL result in serious injury to, or death of personnel, or threatens the primary mission of the ship.

What are the 4 Weapon conditions?

Cooper promulgated most of the following terms: Condition 4: Chamber empty, no magazine in the gun, hammer down, safety off. Condition 3: Chamber empty, full magazine in place, hammer down, safety off. Condition 2: A round chambered, full magazine in place, hammer down, safety off.

What weapons does Condition 2 apply to?

Condition 2 — Applies to Single-Action/Double-Action primarily. This is a magazine inserted, round in the chamber, hammer forward. For revolvers, it would be rounds inserted into cylinder, cylinder locked into place, hammer forward.

Which method of carry is commonly used when no immediate threat is present?

Tactical Carry. The Tactical Carry is used when no immediate threat is present. This carry is employed with the common weapon sling.

Blog about weapons